|
1
Measure room and order crown molding and number
of corners and accessories needed.
2
If using combination corner, square off end not
needed with a saw or large butcher knife.
3
Assemble corners on a flat surface using low
temperature hot melt adhesive, 100% silicone adhesive or
Liquid Nails for foam.
4
Prime and paint crown molding and all accessories
with a single coat latex paint before installing on
wall.
5
Install corners and center blocks first. Use
100% silicone or Liquid Nails adhesive.
6
Measure length of crown needed between corners
and cut with a saw or large butcher knife.
7
Apply a liberal amount of adhesive to back of
crown molding and place against wall. Hold for about 15
seconds to allow adhesive to tack.
8
When finished installing crown fill joints with
sandable spackle or painters caulk. Sand if needed and
touch up with latex paint.
|
